NEETPhysicsProperties of MatterMCQ+4 / −1
The two ends of a metal rod are maintained at temperatures 100oC and 110oC. The rate of heat flow in the rod is found to be 4.0 J/s. If the ends are maintained at temperatures 200oC and 210oC, the rate of heat flow will be
- A8.0 J/s
- B4.0 J/s
- C44.0 J/s
- D16.8 J/s
View written solutionFree
Correct answer: B
As the temperature difference = 10°C as well as the thermal resistance is same for both the cases, so thermal current or rate of heat flow will also be same for both the cases.
More from Properties of Matter
- A wind with speed 40 m/s blows parallel to the roof of a house. The area of the roof is 250 m2. Assuming that the pressure inside the house is atmospheric pressure, the force exerted by the wind on the roof and the direction of the force…2015 · MCQ
- On observing light from three different starts P, Q and R, it was found that intensity of violet colour is maximum in the spectrum of P, the intensity of green colour is maximum in the spectrum of R and the intensity of red colour is…2015 · MCQ
- The approximate depth of an ocean is 2700 m. The compressiblity of water is 45.4 1011 Pa1 and density of water is 103 kg/m3. What fractional compression of water will be obtained at the bottom of the ocean?2015 · MCQ
- Copper of fixed volume V is drawn into wire of length . When this wire is subjected to a constant force F, the extension produced in the wire is . Which of the following graphs is a straight line ?2014 · MCQ
- A certain number of spherical drops of a liquid of radius r coalesce to form a single drop of radius R and volume V. If T is the surface tension of the liquid, then2014 · MCQ
- Steam at 100oC is passed into 20 g of water at 10oC. When water acquires a temperature of 80oC, the mass of water present will be [Take specific heat of water = 1 cal g1 oC1 and latent heat of steam = 540 cal g1]2014 · MCQ
- Certain quantity of water cools from 70oC to 60oC in the first 5 minutes and to 54oC in the next 5 minutes. The temperature of the surroundings is2014 · MCQ
- If the ratio of diameters, lengths and Young's modulus of steel and copper wires shown in the figure are p, q and s respectively, then the corresponding ratio of increase in their lengths would be Includes diagram2013 · MCQ